BSE Full Body with Bumper - Question

Discussion in 'iPhone Accessories' started by ddeadserious, Jul 15, 2010.

  1. ddeadserious macrumors 6502a


    Jul 28, 2008
    Plymouth, MI
    On Tuesday morning, I installed a Bestskinsever body skin(just the sides and the back, no screen).

    I had intended the BSE to protect the back, and the sides to tighten up my semi-loose bumper.

    Well upon installing the bumper today, I can see it's pushing up on the edges of the back skin.

    Like I said, it's been almost 72 hours, so I believe the adhesive is fully cured.

    So my question: Will pulling off the side protection allow the bumper to sit further in and not push up the sides of the back skin?

    Otherwise, any alternative ideas?
  2. offcamber macrumors 6502


    Jun 30, 2007
    I've got the same setup on my phone and don't have a problem with the bumper pulling up the edges of the BSE.
    I think the bumper could be a bit too tight (that's what she said).
    I would not think that removing the BSE from any side would help.
    Some folks had loose fitting bumpers and returned them for one that fit.
    You may want to consider that.

Share This Page