Fusion 3.1 blocking ports in BootCamp?

Discussion in 'Windows, Linux & Others on the Mac' started by MFurrer, Feb 25, 2012.

  1. MFurrer macrumors newbie

    Joined:
    Feb 25, 2012
    #1
    I have fusion 3.1 installed. Windows7 x64

    The programs i need Windows for, connect to a phone system via ports in teh 8000's.
    I have never been able to get these to fully work. It seemed that something was always blocking. Windows firewall off. No MAC firewall.

    So i installed BootCamp. Loaded everything and tested on the Bootcamp partition, all works well.

    Went into MAC, and found I could use VMware on the Bootcamp image....

    Loaded vmware drivers, rebooted and all. Accessed the Bootcamp image from VMWare, and same problem, something blocking same ports...

    If i go directly to the Bootcamp drive and boot, all works well. If I use vmware, no worky...

    Does Vmware block anything? I dont see anything that would indicate that...

    Any help would be greatly appreciated.
     
  2. Sincci macrumors regular

    Joined:
    Aug 17, 2011
    Location:
    Finland
    #2

Share This Page