GuitarLink UGB102 Behringer

Discussion in 'Digital Audio' started by FungusAmongus, Jan 20, 2009.

  1. FungusAmongus macrumors newbie

    Joined:
    Jan 20, 2009
    #1
    Hi People...
    I've brought the behringer ugb102 guitarlink to link my guitar no my MacBook and then to Vox AC30

    the prob is that I use GuitarRig3 and there's too much noise on signal... anyone knows how to remove it?

    Jacks are good, Amp too, the prob isn't guitarrig3...

    any ideas or solutions? :(
     
  2. Drumjim85 macrumors 68030

    Drumjim85

    Joined:
    Oct 7, 2007
    Location:
    DFW, TX
  3. ChrisA macrumors G4

    Joined:
    Jan 5, 2006
    Location:
    Redondo Beach, California
    #3
    Noise ould be coming from the guitar itself. Computers and digital electronics tend to "spray" electronic noise all over. The pickup will "pick up" any electronic noise in the area.

    Also, how are you connecting the AC30 to the Mac's audio out? AC30 expects a high impedance source (like a guitar) but your Mac only has line out which is not a good match at all.

    The way you debug stuff is to remove things from the signal chain and then put them back in untill to re-create the problem
     
  4. FungusAmongus thread starter macrumors newbie

    Joined:
    Jan 20, 2009
    #4
    i connect the ac30 to the behringer guitar link output (phones)...

    guitar is good, amp is good, guitarrig is good....
    just don't understand

    :(
     

Share This Page