Heeeeeeelp :( (Kernel Panics After Installing Leopard)

Discussion in 'macOS' started by soccer1234, Oct 29, 2007.

Most Liked Posts
  1. soccer1234, Oct 29, 2007

    soccer1234 macrumors newbie

    Joined:
    Dec 7, 2006
    #1
    Hi.. I installed leopard.. I booted into tiger double clicked install and it restarted my computer for me. Everything seemed to go fine and than the computer restarted after it was done installing . Now everytime I boot it comes to the "You need to restart your computer message" Anyone have any ideas?:confused:
     
    share
    + Quote Reply
  2. ltlasset, Dec 4, 2007

    ltlasset macrumors newbie

    Joined:
    Dec 4, 2007
    #2
    what else does it say

    What is the entire run down from boot up to "you need to reboot". Have you tried verbose output to see if it tells you an error message? If you boot up and immediately hold apple+V you should get some verbose output.. this would be more helpful.
     
    share
    + Quote Reply
  3. SawTooth500, Dec 5, 2007

    SawTooth500 macrumors member

    Joined:
    Nov 9, 2007
    Location:
    Florence, Arizona
    #3
    Go into single user mode by holding the command key and 'S' down at boot up, then just follow the prompts.
    I think it is type "fsck -fy" which will check and repair the installation. then reboot and see if things are right.
    If not right, now, then do the install again. :p

    Clean install, Archive and install, or update? Update never worked for me, but Clean install and Archive and install both did.:apple:
     
    share
    + Quote Reply
(You must log in or sign up to post here.)

Share This Page