HELP - Windows 7 x64 in VMware Fusion

Discussion in 'Windows, Linux & Others on the Mac' started by Bostonaholic, Aug 24, 2010.

  1. Bostonaholic macrumors 6502

    Bostonaholic

    Joined:
    Aug 21, 2009
    Location:
    Columbus, Ohio
    #1
    I have downloaded the Windows 7 x64 iso using the MSDN licence from my company. I have gone through the setup in fusion and have started the Windows installation but I get the following error message:

    --Load Driver--
    No device drivers were found. Make sure that the installation media contains the correct drivers, and then click OK.

    Can Windows not recognize I'm trying to install from an iso? Should I burn the iso and isntall from the cd drive?

    Thanks.
     
  2. Bostonaholic thread starter macrumors 6502

    Bostonaholic

    Joined:
    Aug 21, 2009
    Location:
    Columbus, Ohio
  3. keeper macrumors regular

    Joined:
    Apr 23, 2008
  4. Bostonaholic thread starter macrumors 6502

    Bostonaholic

    Joined:
    Aug 21, 2009
    Location:
    Columbus, Ohio
    #4
    I downloaded the 32bit version and that installed seamlessly. Then I noticed that the 64bit iso was only 1.9GB and the 32bit was 2.6GB. That can't be right. So I re-downloaded the 64bit version and now it's 2.6GB--must have been a bad download. I'm going to try installing the new 64bit download tomorrow morning--I imagine that was the issue.
     

Share This Page