Hue and iOS 10 Home App

[allenshi]

I recently purchased the Bridge 2.0 w/ 2 Light starter kit.

I got it all set up and the Hue app is working perfectly, but when it comes to the Home app the light bulbs says "No Response".
I restarted the bridge, and re-added it to the Home App and it still does not work.

Has anyone seen this or know of a fix? Also what is the current firmware of the Bridge 2.0?

 

[Alrescha]

Also what is the current firmware of the Bridge 2.0?

I updated my bridge the other day, it is now 01035934. I have not seen the problem you describe, so no help there (I use the Apple Home app exclusively, except for things like firmware updates).

A.

 

[allenshi]

I updated my bridge the other day, it is now 01035934. I have not seen the problem you describe, so no help there (I use the Apple Home app exclusively, except for things like firmware updates).

A.

Yeah thats my version firmware also. I guess i can try and delete the bulbs later and then re-add them.
WHen you set up your hue bridge and lightbuld, did you set it up via the app and then add it in the home app?

 

[Alrescha]

When you set up your hue bridge and lightbulbs, did you set it up via the app and then add it in the home app?

I have had Hue stuff since the beginning, so my pre-HomeKit v1 bridge configuration was copied to my v2 bridge. I then enabled Siri voice control in the Hue app.

I played with Elgato's Eve app, but when iOS 10 came along I was able to get rid of that.

A.

 

[allenshi]

when i get home i'll see if its related to siri. i'll remove the siri portion of it first

 

[LiveM]

Enable two-factor authentication in iOS.

 

[allenshi]

Enable two-factor authentication in iOS.

that was done.

But i ended up resetting the bridge and re doing from the start and it seem to work

 

[CharlesShaw]

Home app with Hue was working perfectly from 9/13 (iOS 10 launch) until this morning when all the bulbs in the Home app displayed the "No response" status. The Hue app still worked. I tried restarting the bridge, the iPhone, but it was removing and re-adding the bridge from the Home app that resolved the issue. Unfortunately, the bulbs all went back to "Default Room" and my lighting scenes must be recreated.

 

[dest]

I get no response when the bulb has been turned or by the normal switch rather than leaving the switch on and turning the bulb off with HomeKit or the hue app

 

[LiveM]

If you use the normal switch you're cutting its power supply, so it can't be seen by Home until it can resume operation.