Iphone 3g Bezel Sepertion after Housing Replacement

Discussion in 'iPhone Tips, Help and Troubleshooting' started by michaelclaw, Dec 18, 2012.

  1. michaelclaw macrumors newbie

    Joined:
    Nov 24, 2012
    #1
    Hello,

    I Just replaced the back housing and when i reassambled it all fitted but the right side of the iphone is coming u. the left side is even completely down.
    im going to upload some pictures to show you. Anyone know how to fix this? thanks


    **Edit

    i spelled Separation wrong sorry.
     
  2. kingdLo macrumors 6502

    Joined:
    Mar 20, 2009
    #4
    You're supposed to glue the bezel to the housing to make it flush. The quality of the aftermarket housings also aren't too great and can cause this problem
     
  3. michaelclaw thread starter macrumors newbie

    Joined:
    Nov 24, 2012
    #5
    if i glue it what kind of glue and also how would i open it again once its glued?
     
  4. michaelclaw thread starter macrumors newbie

    Joined:
    Nov 24, 2012
    #6
    ok after reading im going to go buy some rubber cement glue.
     
  5. michaelclaw thread starter macrumors newbie

    Joined:
    Nov 24, 2012
    #7
    http://imageshack.us/f/171/img0007jy.jpg/

    i got this glue

    anyone know what i can use to apply it to the case?

    the instructions for this is i put put half/half of each tube on foil then apply to surface.

    anyone know?
     

Share This Page