iphone 3gs, intermitant after replacing the glass and digitizer

Discussion in 'iPhone Tips, Help and Troubleshooting' started by CrannyT, May 14, 2011.

  1. CrannyT macrumors newbie

    Joined:
    May 14, 2011
    #1
    Just bought the 3gs, broke glass and replaced with kit. All went according to plan, however once everything was replaced, the display powered on, phone works, can hear it ring, but I cant use the touch screen. Any ideas?
     
  2. gman34 macrumors member

    Joined:
    Jun 26, 2009
    #2
    Cable between chip and glass was disconnected. open it and fix it.
     
  3. Crystal-RX macrumors 68030

    Crystal-RX

    Joined:
    Dec 22, 2008
    Location:
    Seattle, WA USA
    #3
    There are 3 cables connected the screen assembly to the logic board.

    1. Cable #1 is for LCD
    2. Cable #2 is for the digitizer
    3. Cable #3 is for ear piece and sensor proximility

    I think your cable # 2 is somehow loose/disconnected when you put press the top in.

    Just open it and be careful this time to make sure everything is tight before close it.
     

Share This Page