iPhone Iphone 3GS Ipad baseband

Discussion in 'Jailbreaks and iOS Hacks' started by ssmin, Jul 8, 2012.

  1. ssmin macrumors newbie

    Jul 8, 2012
    I have an iPhone 3GS, sn 88130... 5.1.1, model MB718LL, new br, I think it is a refurb from apple.
    I flashed it to the iPad baseband and now I have no wifi nor Bluetooth. No modem firmware no iccid info.
    Tried to downgrade to 05.3.14 but I don't see any change.
    While flashing and downgrading I noticed that the phone would be Stuck at the "flashing baseband don't interrupt" screen for a few minutes and from there went straight into rebooting itself even tough the status bar was showing half completion.
    The phone boots, stays on for a few minutes and then reboots by itself.
    It does it continuously till it runs out of battery.
    Have I just bricked my phone? Is there something I can do about it ?
    Please help. Thanks
  2. Applejuiced macrumors Westmere


    Apr 16, 2008
    At the iPhone hacks section.
    You ruined the phone.
    You cannot install the ipad baseband on that 3GS since its the newer with the fixed baseband. Next time ask and verify before you do something that could potentially render your phone useless.
    You fried all the radios in it and there's no way to undo it unless you replace the logic board.
  3. biohead macrumors 6502

    Jun 18, 2010
    West Drayton, UK
    What he said^

    Your 3GS was too new for the iPad baseband - so you've bricked the radio permanently.
  4. dhlizard macrumors G4


    Mar 16, 2009
    The Jailbreak Community
    You have already received the answer to this on DevTeam Blog.
    We gave you the same info "Juice" gave you.

    Remember we advised you not to try this when you first asked and you tried it anyway.
    And fried your bb chip.

    ssminxxl thread
    ssminxxl11p · 14 hours ago
    I have an Iphone 3GS sn 88130 on 5.1.1 ..... is it possible to flash the baseband to the Ipad 06.15.00 ???
    Block IPDelete Report
    13 replies · active 26 minutes ago
    slavakulikoff130p · 13 hours ago
    No! Too close to cut off line.
    Block IPDelete Report
    dhlizard139p · 13 hours ago
    I agree, some xx128 phones have been damaged by flashing iPad baseband
  5. LandonDonovan macrumors regular

    Jun 24, 2010
    I've heard iPhones from xx127 to xx134 and higher have the incompatible baseband ending in EH instead of EE. You just have to flip over the lower shielding if you fall into that range to verify although as you get further and further away from xx134, you're more likely to have it and brick your iPhone. If you have the 5K as the first 2 digits, there's a chance that you have the compatible baseband, but it's still less likely than under xx127.

    You'll need to swap the baseband now through a service, which costs anywhere from $50 to $100.

Share This Page