IPhone 5c screen replacement

Discussion in 'iPhone Tips, Help and Troubleshooting' started by oddbod73, Feb 21, 2015.

  1. oddbod73 macrumors newbie

    Nov 20, 2014
    Hi all 2nd time I've replaced daughters screen, 1st time was fine no issues, this time however the screen has the back light on & nothing else when I connect to the power cable the phone constantly vibrates. I've checked all the ribbons etc all connected, any help appreciated! Thanks
  2. Bomb Bloke macrumors regular

    Bomb Bloke

    Feb 12, 2015
    Tasmania (AU)
    Did you disconnect the battery while performing the change over?

    Try a hard reboot - hold the power button and home button together until the phone turns off, then continue holding until it turns on again.

    If you're unable to tell if the phone is turning off/on, simply hold the two buttons together for a full two minutes.
  3. ray.arl macrumors member

    Jan 12, 2015
    While connecting the ribbon cables, did you do that for more than once/connector?

    It may be the so called "gold finger" of the connector is deformed, check it up!

Share This Page