iPhone Assembly - Connecting Digitizer Ribbon

Discussion in 'iPhone Tips, Help and Troubleshooting' started by boldfacelies, Dec 17, 2008.

  1. boldfacelies macrumors newbie

    Joined:
    Dec 17, 2008
    #1
    Bought a full replacement assembly, lcd+digitizer+glass+bezel, and am trying to connect the 1 ribbon and 2 snap-connector lines. Having lots of trouble figuring out how to gently and safely connect the Ribbon (the one that goes under the connector that you have to lift up to a 45degree angle and shut).


    Any advice on a tool, or how far to get it in before it works? I'm getting frustrate after a few hours of trying.

    Thanks!
     
  2. Tastannin macrumors 6502

    Tastannin

    Joined:
    Sep 19, 2003
    Location:
    UT
  3. boldfacelies thread starter macrumors newbie

    Joined:
    Dec 17, 2008
    #3
  4. boldfacelies thread starter macrumors newbie

    Joined:
    Dec 17, 2008
    #4
    Really? Nobody has tips? I just need to repair mine, I'm not going into business!!
     

Share This Page