iphone jailbreak help

Discussion in 'iPhone Tips, Help and Troubleshooting' started by kenny1991, Sep 22, 2008.

  1. kenny1991 macrumors newbie

    May 5, 2008
    HEY I HAVE HAD MY IPHONE FOR 5 MONTHS I HAVE JUST SOLD IT ON EBAY AND I just restored it to its original factory settings. It was a version 2.0.2 firmware. It now is at the screen where it says insert into itunes on the screen. The thing is tried downloading the new Quickpwn to re jail break it however, it says it does not support my firmware.. how do i check my firmware? My old firmware was 1.1.4, so im guessing thats what im at now after doing the restore... How do i re jail break it to the newest version? because i want it to be up to date for the new buyer. thanks
  2. neesh0 macrumors 6502a


    Sep 6, 2008
    Toronto, Ontario
    go to www.winpwn.com and get the full pwnage tool, im assuming this is a 1st generation iphone, so it will unlock/activate/ jailbreak your phone
  3. kenny1991 thread starter macrumors newbie

    May 5, 2008
    where can i download the newest firmware? is there a link sumone can give me?
  4. jtravapd macrumors newbie

    Sep 22, 2008
    if your selling an old phone, the easiest thing to do , is do a complete erase of all data and settings from your phone...takes like 2 hours...once thats done, connect it to itunes and download and update the newest firmware but dont synch any of your contacts ect....then download quickpwn and jailbreak it. then your done and the person will be getting a clean newly installed system with no problems.
  5. kenny1991 thread starter macrumors newbie

    May 5, 2008
  6. warmsa macrumors newbie


    Sep 24, 2008
    When you jailbreak with the Quickpwn program, you need to do the right version that your iphone has (now you're 2.0.2, then choose the right one).
    The program will ask you to select it.

    Download links below:

    Original Firmware - iPhone 1st generation

    Firmware 1.1.4 (162 Mb)

    Firmware 2.0.2

    Good luck :)

Share This Page