Keep getting only one bar signal strength

Discussion in 'Jailbreaks and iOS Hacks' started by H3nk387, May 18, 2011.

  1. H3nk387 macrumors newbie

    Joined:
    Jul 8, 2010
    #1
    Hi,

    Sorry if this has been asked before (probably has 100s of times).

    I had 4.1 (jailbroken) on my iPhone 4 and decided to upgrade to 4.3.3. I did this using Pwnagetool successfully, but now I only get one bar in signal strength all the time.

    Will redoing the whole procedure with Redsn0w fix this? And does that upgrade my baseband? Do I even need to care about my baseband?
    I'm on my original provider (Telia) and have no plans to switch before my time with them is up.

    Thanks,
    Henke
     
  2. dudeabiding macrumors 6502

    dudeabiding

    Joined:
    Aug 24, 2009
    #2
    Did you do a .... search... here using the term "one signal bar" or similar term? You might.
     
  3. H3nk387 thread starter macrumors newbie

    Joined:
    Jul 8, 2010
    #3
    I did, however I left out the " ". Got better results this time around. Gonna try to restore to 4.3.3 and just using Redsn0w instead.
     
  4. psywzrd macrumors 68030

    Joined:
    Feb 6, 2008
    #4
    You must not have looked very hard. You don't need to do anything other than install ultrasn0w. Why go through the hassle of jailbreaking again?
     

Share This Page