Loose screw on RAM access point...

Discussion in 'iMac' started by avantgardener, Sep 30, 2007.

  1. avantgardener macrumors newbie

    Joined:
    Sep 30, 2007
    #1
    I popped in a couple new 1gig sticks into my iMac, but now I can't seem to screw the door shut. Either the screw is a bit worn out at the tip or I'm not catching the screw guide. The door doesn't seem to sit flush with the rest of the frame! Any tips on getting it to screw tightly??
     
  2. rjedoaks macrumors newbie

    Joined:
    Sep 16, 2007
    #2
    Sounds like the new stick didn't seat properly

    My 2 gig stick did not just slide in. Took a bit of manuvering to seat properly.
     
  3. HLdan macrumors 603

    HLdan

    Joined:
    Aug 22, 2007
    #3
    Yeah, the ram isn't seated properly. The door should close easily and flush without force.
     
  4. Bobioden macrumors 68000

    Bobioden

    Joined:
    Sep 23, 2007
    Location:
    Denver
    #4
    Mine was the same way. Make sure the card is firmly in place. I would try taking it out and re-installing it. The door shoud fit flush and screw easily.
     
  5. ClassicBean macrumors 6502a

    Joined:
    Jun 20, 2004
    Location:
    Torontoland
    #5
    When I installed ram, i couldn't seem to get the screw in either. I was trying to screw it like one would with a traditional screw. It seemed that I had to push to screw in and then give it a quick turn.
     

Share This Page