Mac Mini power supply voltage

Discussion in 'Alternatives to Mac Hardware' started by NCMau, Dec 10, 2018.

  1. NCMau macrumors newbie

    Joined:
    Mar 6, 2008
    Location:
    NC
    #1
    Mid 2010 Mini. No power. Done PMU reset several times. I removed the power supply and measured 11+ voltage from the first 4 pins of the connector to the logic board. I am hoping that the PS is defective and not the logic board.
    1. Is this the correct voltage and should there be additional voltage from the other pins?
    2. The on-board battery measure 2.6V. Could this low voltage cause my "no power" problem?
     
  2. AndyMacAndMic macrumors 6502a

    AndyMacAndMic

    Joined:
    May 25, 2017
    Location:
    Amsterdam, Netherlands
    #2
    Why do you post this in the 'Alternatives to Mac Hardware' thread?
     
  3. NCMau thread starter macrumors newbie

    Joined:
    Mar 6, 2008
    Location:
    NC
    #3
    --- Post Merged, Dec 10, 2018 ---
    I posted this thread to the Alternative to Mac Hardware by error. I can't find a way to delete it. I reposted it to the proper one.
     
  4. AndyMacAndMic macrumors 6502a

    AndyMacAndMic

    Joined:
    May 25, 2017
    Location:
    Amsterdam, Netherlands
    #4
    OK. I just mentioned it because you will probably not get a lot of responses on your question in this thread ;)
     

Share This Page

3 December 10, 2018