Mac Plus narrow display

Discussion in 'Apple Collectors' started by rfostoria, May 15, 2013.

  1. rfostoria macrumors newbie

    Joined:
    Jan 4, 2013
    #1
    I have a Mac Plus that was having some display issues so I replaced the analog sweep board. The issues that I were having are gone and the display seem to work perfectly except that the height is way out of whack. It's centered just fine vertically and it's the correct width, but its only about an inch tall. Everything is there, it's just compressed. I opened up the case and even with the height adjustment cranked all the way in the positive direction it's way too small. Is this a common problem and is it easily fixed?
     
  2. MacTech68 macrumors 68000

    MacTech68

    Joined:
    Mar 16, 2008
    Location:
    Australia, Perth
    #2
    I've never known a partial vertical height failure on these power-sweep boards (which is not to say there isn't a failure possible).

    If the machine is otherwise powering up and running, then it's difficult to pinpoint a particular component.

    Have you checked the 5 & 12 volt rails and adjusted accordingly?
     

Share This Page