Newbie: Motion Graphics quit displaying handles when importing image

Discussion in 'Digital Video' started by bMorpheus, Feb 19, 2009.

  1. bMorpheus macrumors newbie

    bMorpheus

    Joined:
    Feb 18, 2009
    Location:
    Texas
    #1
    When opening a New project: For some unknown reason whenever I place an image/pic into the canvas area there isn't any handles where I can size up or down the image.

    This also happens when adding a kaleidoscope filter.

    I opened another file I had worked on previously and the handles are there.

    I can navigate to the Inspector and use the controls there, but that seems counter productive, especially when using filters.

    What do you suppose is happening and not can I fix it?.?.?

    I would appreciate any advice on this subject. BTW: I'm using FCP 5.5, Motion 2.1.2

    ;)
     
  2. Digital Skunk macrumors 604

    Digital Skunk

    Joined:
    Dec 23, 2006
    Location:
    In my imagination
    #2
    Press Command and slash (or question mark), you should be fine then.
     
  3. bMorpheus thread starter macrumors newbie

    bMorpheus

    Joined:
    Feb 18, 2009
    Location:
    Texas
    #3
    Thank you ever so much

    It worked, it worked:)

    I didn't know what to look for in the manual. :eek:

    Thanks again, now I won't have to keep pulling my hair out.

    BTW: Do you know anything about PS?.?.? I have a question in the graphics forum, that so far no one has answered. I'm not sure if they understand my problem, or no one knows how to answer my question.

    http://forums.macrumors.com/showthread.php?t=654086
     

Share This Page