Playing music through Powerbook to mixer ?

Discussion in 'PowerPC Macs' started by frozencarbonite, Dec 7, 2006.

  1. frozencarbonite macrumors 6502


    Aug 3, 2006
    I'm going to be djaying (I'm using the term very, very loosely :) ) some events for my church and want to use my Powerbook to play the music through a sound system. I'll be running it to a mixer first and then to 2 monitors.

    Has anyone ever do this? If so, what will I need to configure on my Powerbook to do this? Or will I be able to just hook up the cables and play music from iTunes?

    I will be looking at the actual mixer this coming Sunday to see what type of cables I'll need. Hopefully I can find the right kind.

    Thanks for any help you can give.
  2. jimijay macrumors newbie

    Dec 2, 2006
    This is simple-- You play the audio from iTunes out the headphone jack.
    I'd start with iTunes volume slider all the way up and system volume at about 3/4. You want to send a decent signal but not too much for distortion. I'd lay off the EQ inside of iTunes and handle it on the board.

    Radio Shack will be your best bet for cabling/adapters. I'll give you a few options:

    1) 1/8" male stereo mini ---->RCA male plugs (LEFT and RIGHT channels, usually the colors are red and white or red and black) this is available as a cable in different lengths but not too long, good if the laptop will be next to the mixer.


    2) If you need to send the signal over 10 ft:
    1/8" male stereo mini to 2, 1/4" female adapter ----> 2, 1/4" cables (guitar cables) ---->2 direct boxes ----> XLR (microphone) cables to the snake or direct to mixer.

  3. frozencarbonite thread starter macrumors 6502


    Aug 3, 2006
    Thanks so much for your help.

Share This Page