PS Crystal Film and Bumper Installation

Discussion in 'iPhone Accessories' started by WesCole, Aug 29, 2010.

  1. WesCole macrumors 6502a

    Joined:
    Jul 1, 2010
    Location:
    Texas
    #1
    Hello,

    I am getting my crystal front and back screen protectors for my iPhone 4 tomorrow and had a question about installation.

    Should I install the films first with the bumper off or should in try to put them on with the bumper in place?

    Thanks,

    Wes
     
  2. FieldingMellish Suspended

    Joined:
    Jun 20, 2010
    #2
    Bumper off.
     
  3. WesCole thread starter macrumors 6502a

    Joined:
    Jul 1, 2010
    Location:
    Texas
    #3
    Thanks. Is there anything I should know when putting the bumper back on in order to avoid any bubbles?

    Thanks,

    Wes
     
  4. WesCole thread starter macrumors 6502a

    Joined:
    Jul 1, 2010
    Location:
    Texas
    #4
    Bump...in hopes that someone may have some advice for putting the bumper back on before I tackle this project in and hour. :)

    Thanks,

    Wes
     
  5. rockyroad55 macrumors 601

    rockyroad55

    Joined:
    Jul 14, 2010
    Location:
    Phila, PA
    #5
    You shouldn't have an issue putting the bumper on as your normally would.
     
  6. WesCole thread starter macrumors 6502a

    Joined:
    Jul 1, 2010
    Location:
    Texas
    #6
    Well, I got it put on after several attempts. :)

    Now, I just have one small bubble by the front facing camera and one by the home button. Not sure if these will go away with use, but everything else (front and back) is smooth as glass.

    Wes
     

Share This Page