Become a MacRumors Supporter for $50/year with no ads, ability to filter front page stories, and private forums.

mufasa

macrumors member
Original poster
Sep 14, 2007
69
0
Practically fully Automated Windows Jailbreak Install here by planetbeing!!

--------------------------------------------------------------------------------

EDIT New Version AVaiable, cuts out more steps, get it HERE!!

http://zoo.cs.yale.edu/~yw226/ipod/touchfree3.zip

NOTE THAT .NET FRAMEWORK 2.0 IS REQUIRED FOR THIS APPLICATION

1. Extract all of the files in this zip archive.

2. Copy iTunesMobileDevice.dll from C:\Program Files\Common Files\Apple\Mobile Device Support\bin to the same folder as touchFree.exe.

3. Restore your iPod to a fresh 1.1.1 state (recommended but optional)

4. Load http://jailbreak.toc2rta.com in Safari on the iPod. Safari should exit/crash.

5. Run touchFree.exe

- When prompted to reboot, turn off the iPod as you do so normally and then turn it on again.
After the springboard (the UI of the iPod) appears on the iPod, push enter in the window to continue
(the application cannot detect when the iPod has been successfully booted, so you need to cue it by
pushing enter when asked to)

- You will be asked to reboot twice at some point. This means turning the iPod off, turning it on,
turning it off again, and then turning it back on before pushing enter to continue.

- Enter the IP address of the iPod when prompted.

- If you get a PuTTY dialogue about the SSH host key, say yes.

6. You should end up with an iPod with Installer.app and Trip1Pogostick installed, and SSH, SFTP enabled.

- Username to SSH is root, password is alpine

-----------------------------------------------------------------
1. wuts a springboard?
2. ok im on step 5
 
how come i cant sync to itunes after jailbreaking/3rd party apps. It just says software for iPhone not found, reinstall itunes by clicking on installer blah blah blah. Did i do something wrong?
 
Register on MacRumors! This sidebar will go away, and you'll see fewer ads.