Re-spring loop on a JB'd 4.2.1 iPad

Discussion in 'iPad Hacks' started by BookEmDanno, Feb 2, 2011.

  1. BookEmDanno macrumors member

    BookEmDanno

    Joined:
    Nov 9, 2010
    Location:
    State of ~Aloha!~
    #1
    I installed a deb (directly in terminal). I had to do a re-spring as was required, but after doing so, i am stuck on a loop - passcode entry screen (could enter my number though) <--> pineapple respring screen ---> passcode entry. Then the cycle continues.

    Any advise is appreciated.

    Aloha!
     
  2. Fabricman112 macrumors regular

    Fabricman112

    Joined:
    Apr 3, 2010
    #2
    if you have ssh running, "dpkg -r packagename"
     
  3. BookEmDanno thread starter macrumors member

    BookEmDanno

    Joined:
    Nov 9, 2010
    Location:
    State of ~Aloha!~
    #3
    I was planning to do that - uninstall via dpkg.

    But I can't get past the passcode entry screen - respring loop. So I am at a point where I can't go back to the home screen. Do you think i can just re-jailbreak?

    Thanks for the prompt response - Mahalo
     
  4. Fabricman112 macrumors regular

    Fabricman112

    Joined:
    Apr 3, 2010
    #4
    i meant u could log in via ssh from your computer, but if ssh isnt running it wont work of course ;)

    worst case is a restore and re-jb

    i dont have any passcode (only sim-pin) and running 4.3 beta i tried winterboard... had to remove the ssh-bash way
     

Share This Page