Remove dust between screen and casing

Discussion in 'Apple Watch' started by EdisEdward, Jun 3, 2015.

  1. EdisEdward macrumors 6502

    Joined:
    Feb 4, 2013
    #1
    I noticed that there are some small dust particles between my screen and the casing. I tired using a thin post it note to get it out, but it looks like it just pushed it in deep and I'm worried it will go under the screen now. Anyone else have issues?
     
  2. Armen macrumors 604

    Armen

    Joined:
    Apr 30, 2013
    Location:
    127.0.0.1
    #2
    Uh, I don't think dust is supposed to even get under the screen like that. Call Apple. They may just replace your watch.
     
  3. Mac 128 macrumors 601

    Mac 128

    Joined:
    Apr 16, 2015
    #3
    You should take a look at the iFixIt teardown. They crystal is glued tight to the case, nothing should slide underneath it. To the extent a spec of something did slide under the edge of a part of the crystal that didn't get glued complete to the case, it's no going any further. Then again, this could be the sign of a bigger problem so best to take it to the Apple Store. But don't be surprised when they look at you funny because you tell them there's a spec of dust under the crystal that they can't see.
     
  4. EdisEdward thread starter macrumors 6502

    Joined:
    Feb 4, 2013
    #4
    hmm, no else has a this problem? no one else has a gap between the screen and the casing? like a 1mm (or less) gap?
     
  5. T-Will macrumors 6502a

    T-Will

    Joined:
    Sep 8, 2008
    #5
    Rinse it under some warm water for 10-15 seconds and dry with a soft cloth.
     

Share This Page