I have an iPad 1 (running 5.1.1). I have a dock connector -> HDMI cord. If it helps, here are the specs on the cord I'm using: http://www.flickr.com/photos/100470807@N06/9918602966/ I have gotten mirroring to work. Without resupported, I can get mirroring to work (a message pops up from displayout telling me that a display is connected, and it successfully mirrrors), but it only successfully works for 1:42. After that, it tells me that the display has been disconnected and THEN gives me the "This accessory not supported by iPad" message. So I know the cord I'm using is an older one that is no longer supported. Long story short, resupported 4+ will not work on my iPad 1 and the HDMI cord. It won't. And TVout 2 doesn't enable old cords. Leave that as a fact and move on, please. My question is what can I do to mimick the function of Resupported? Clearly installing Resupported changes some setting or text in a file. Is there any way to manually replicate the function of Resupported in the filesystem, enabling the use of unsupported cords?