Resolved Series 2 Bricked by Beta 2 Update?

Discussion in 'Apple Watch' started by scottct1, Jul 2, 2017.

  1. scottct1 macrumors regular

    scottct1

    Joined:
    Jun 7, 2012
    Location:
    Connecticut USA
    #1
    This morning I upgraded my Series 2 to Beta 2 from Beta 1. All seemed to go fine including the fact it told me the watch was successfully updated. However on the watch is the Apple Logo with the dashes on the outside, and all of the dashes are filled in. (Like you see when it is doing a software update.) and now this screen has been on for hours.

    After 3 hours I pressed and held the two buttons on the side until it rebooted, when it rebooted it came up on the screen again with the Apple and the dashes quickly filled in and is now full, however it is sitting on the screen with the screen lit... It is still on the charger.

    What do I do?
     
  2. Julien macrumors G4

    Julien

    Joined:
    Jun 30, 2007
    Location:
    Atlanta
    #3
    If you are a developer you can send it to Apple to be restored.
     
  3. scottct1 thread starter macrumors regular

    scottct1

    Joined:
    Jun 7, 2012
    Location:
    Connecticut USA
    #4
    Got it... I pressed and held both buttons for 10 seconds until it shut off and then kept holding them until I saw the Apple logo.

    Waited again and it asked me for the passcode it did the loading screen thing again his time quickly and then it fully loaded up and is working now. (Yes!)
     

Share This Page