Silent switch

Discussion in 'iPhone' started by gtqi, Aug 1, 2008.

  1. gtqi macrumors newbie

    Joined:
    Jul 12, 2008
    #1
    I was wondering if anybody has a problem with that...
    couldn't find any problems reported in the entire forum.

    My brother got an iphone too and his silent switch needs a lot of more pressure to turn on/off. Mine on the other side is very easy to switch that I am thinking
    it could be too easy and it will fall off in the near future...


    Should I be scared about that?
     
  2. coolant113 macrumors 6502

    coolant113

    Joined:
    Jun 12, 2007
    Location:
    New Jersey
    #2
    Mine Always hits my case when i pull it out it always goes to silent:apple::apple:
     
  3. bit_bucket macrumors regular

    bit_bucket

    Joined:
    Jul 18, 2002
    Location:
    West By God VA
    #3
    Go for a replacement. This is a manufacturing defect that will lead to the switch falling off within a few days.
     
  4. WillJS macrumors 65816

    WillJS

    Joined:
    Jan 6, 2007
    #4
    That loose, eh? Mine's rather on the stubborn side.. I'd get it looked at. :)
     
  5. redbill macrumors newbie

    Joined:
    Jul 31, 2008
    #5
    mine was like that . . . until it broke off. It seems to be a small number that are tight and hard to switch - even crooked sometimes. get it replaced. my new one is much easier to switch
     
  6. gtqi thread starter macrumors newbie

    Joined:
    Jul 12, 2008
    #6
    well I am not sure if I explained the situation right before...

    Are the defective ones

    -those where you need more pressure?
    -the switch goes easily?

    I am scared that mine goes too easy and will fall off...
     

Share This Page