Small machining defects on 15"?

Discussion in 'MacBook Pro' started by Totti, May 18, 2010.

  1. Totti macrumors member

    Joined:
    Nov 4, 2008
    Location:
    Melbourne, AU
    #1
    Just curious to see how many others have these? Any sort of little chips on the bottom from the machining process. I care not, as who really cares about a <1mm chip (Although most on this board probably would)

    My last 15" Unibody had one also and drove me absolutely nuts. I have a feeling it was all the trawling from this board that led to go to such microscopic lenghts to obtain the perfect slab! This time around though it's a non-issue.
     
  2. RossMc macrumors 65816

    RossMc

    Joined:
    Apr 30, 2010
    Location:
    Newcastle, UK
    #2
    The speaker holes were not cut out properly on mine like there was a few of them which were out of line compared to the rest but Apple replaced it straight away.
     
  3. Totti thread starter macrumors member

    Joined:
    Nov 4, 2008
    Location:
    Melbourne, AU

Share This Page