Updated Watch to 4.0.1, now won't get cell signal

[bbeagle]

I bought an 42" aluminum cellular Apple Watch yesterday.

I paired my watch and phone, set up AT&T cellular. I went outside and tested it immediately. Great signal. I used it last night and this morning. Worked great.

Today I updated to 4.0.1, now I can't get a cell signal at all. On the Explorer face, you can see that it's looking for a signal, but never gets one.

I rebooted both the watch and the phone, unpaired and paired them back. I've been trying for the past 4 hours, but no signal. I might have to call AT&T to see what's wrong after a software update.

Anyone else have this issue?

 

[Achilles75]

Try swiping up to get your "settings," turn the cellular connection off, wait 10 seconds or so, turn it back on.

 

[bbeagle]

I've done exactly that about 5 times. Nothing.

When you go to the Explorer face, it shows that it's trying to get a signal by the green dots opening and closing. The signal is never achieved.

I think it's an AT&T thing, not a watch thing.

 

[bbeagle]

Solved. I reset the watch, then unpaired and re-paired to the iPhone.

Cell signal now works again.