upgrading UMB hard drive and the stupid retention bar

Discussion in 'Mac Basics and Help' started by AmeliaO, Mar 30, 2009.

  1. AmeliaO macrumors newbie

    Joined:
    Feb 22, 2009
    Location:
    Fort Myers, Florida
    #1
    hey how's it going,
    I'm upgrading my aluminum macbook hard drive(or at least i was trying too)
    until i realized that i don't have a #00 philips screwdriver and that i have a #0 P SD.
    i have the torx t6 for the screws on the outside. my question is, is there anything else too take this retention bar out or anyway around it? i don't wanna strip the tiny screw by shoving something else thicker in.
    please help =(
     
  2. BlueRevolution macrumors 603

    BlueRevolution

    Joined:
    Jul 26, 2004
    Location:
    Montreal, QC
    #2
    If you go carefully you may still be able to use a #0 driver. The small-headed screws are often not very tight.
     

Share This Page