How to Jailbreak 2.2 http://www.youtube.com/watch?v=K3Q8K79wZt8 In this guide i will explain how to jailbreak your iphone 3g, iphone edge, or ipod touch 1g on the new 2.2 firmware. Before you begin make sure you are on a stock 2.2 firmware. I do not recommend starting from a jailbroken 2.1 device. Just start fresh. If you need to know how to restore your firmware check out our guide here: Restoring your Device Step 1: Go to the Dev Team iPhone Blog to download Quickpwn 2.2. Scroll down until you find the download section. Download Quickpwn 2.2 for your operating system Step 2: Open up the Quickpwn application Step 3: Click 'ok' on the dialog box Step 4: Connect your device to your computer and then click 'ok' on the dialog box Step 5: When Quickpwn asks you to change your boot logos I recommend you dont. If something goes wrong and your stuck at the boot logo with a nice little pineapple, Apple will not replace your device. Protect your investment and click no Step 6: Quickpwn will now build the IPSW. Just wait about 1 min Step 7: Turn off your device Step 8: Now you are going to put your device into DFU mode. Just follow the on-screen instructions and you will be fine. This mode enables Quickpwn to flash your device. Step 9: An iTunes error popup might appear. Just hit ok Step 10: Now Quickpwn will do its magic. You should see this information on your screen and then Step 11: Now a dialog box should appear under Quickpwn. Hit 'ok' but do not disconnect your device from your computer. In fact, dont touch it! Step 12: Your iPhone or iPod Touch's screen should show this image with a progress bar. This takes about 1-2 min. Step 13: Your iphone should reboot and you will be good to go!