windows 7 cant see g5 powermac in target disk mode

Discussion in 'Mac Basics and Help' started by Anarchy99, Jul 16, 2010.

  1. Anarchy99 macrumors 6502

    Joined:
    Dec 13, 2003
    #1
    its not quite a mac problem but, i have a g5 powermac with a hfs+ drive and a ntfs drive using target disk mode
    windows 7
    under disk drive in device manager
    AAPL UNKNOWN MODEL IEEE 1394 SBP2 Device with a small yellow explanation mark and says
    This device cannot start. (Code 10)

    this works under linux and osx86 on this laptop so its definitely a windows issue but im not sure how to fix it

    i tried this: http://support.apple.com/kb/TS3165

    windows installed the driver fine but if i plug in the device it goes to a black screen for about 2 seconds then it resets the pc
    upon bootup if i have it plugged in it blue screen of death's
    with it unplugged it rebooted normally windows popped up with this info after reboot

    Problem signature:
    Problem Event Name: BlueScreen
    OS Version: 6.1.7600.2.0.0.256.1
    Locale ID: 1033

    Additional information about the problem:
    BCCode: ca
    BCP1: 0000000000000001
    BCP2: FFFFFA800567CAE0
    BCP3: FFFFFA800567CDA0
    BCP4: 0000000000000000
    OS Version: 6_1_7600
    Service Pack: 0_0
    Product: 256_1

    wiindows found no soluton
    any other ideas or ideas how to fix the BSOD

    thanks
     
  2. sean12321 macrumors newbie

    Joined:
    Nov 23, 2011
    #2
    Did you ever find a solution to this problem? I am trying to connect my Macbook to a PC via Target Disk Mode and can't seem to get it to pop up as a readable hard disk. Any advice?
     

Share This Page