Problems after attempting WinPwn.

Discussion in 'Jailbreaks and iOS Hacks' started by EthanNixon, Apr 17, 2008.

  1. EthanNixon macrumors 6502a

    EthanNixon

    Joined:
    Sep 30, 2007
    Location:
    New Jersey
    #1
    I decided to restore my phone and try WinPwn since there was some hype around it. Well after doing so, it wouldn't recognize any ipsw's AFTER pwning my phone. I can't restore through iTunes, I get an error 1012. I can't do anything with my phone. So I tried ZiPhone again, it got me into the phone and jailbroke it... Now I have no service with ATT. I need some help!
     
  2. spinstorm macrumors 65816

    Joined:
    Sep 14, 2007
    #2
    I am guessing you SO DID NOT read the FAQ.

    1. Put phone in recovery mode (winpwn) may do it for you.
    2. Press "iPwner" button - phone will reboot when finished.
    3. Make custom firmware. Tick baseband update AND Activate.
    4. Put phone into recovery mode.
    5. Ctrl + restore in itunes to select the custom firmware you just made.
    6. Phone will restore and boot up activated with installer.
    7. Set phone up as NEW - do NOT restore from back-up.

    Your error message is most likely due to you NOT putting the phone into restore mode when you used the custom firmware.

    Put phone into recovery mode and use the custom firmware.

    If you did NOT tick activate make a new firmware with that ticked!
     
  3. EthanNixon thread starter macrumors 6502a

    EthanNixon

    Joined:
    Sep 30, 2007
    Location:
    New Jersey
    #3
    EDIT:

    Nevermind, it still didn't work. I get the error (1015) still.
     
  4. EthanNixon thread starter macrumors 6502a

    EthanNixon

    Joined:
    Sep 30, 2007
    Location:
    New Jersey
    #4
    Do I need an older version of iTunes? I put my newer .dll file in the CMW folder, and now it keeps crashing.
     
  5. spinstorm macrumors 65816

    Joined:
    Sep 14, 2007
    #5
    explain EXACTLY what you did...
    every step

    did you try the 2.0 beta firmware as well?
     
  6. jav6454 macrumors P6

    jav6454

    Joined:
    Nov 14, 2007
    Location:
    1 Geostationary Tower Plaza
    #6
    Tell me step-by-step what you did and which firmwares you used. Please remember firmware 1.2.0 a.k.a 2.0 beta is not supported at this time by WINPWN.
     
  7. spinstorm macrumors 65816

    Joined:
    Sep 14, 2007
    #7
    1012 is because your baseband does NOT match your firmware.

    You must either have upgraded to 2.0 beta and NOT gone to 1.1.4 first or gone down to a lower firmware than the baseband.

    Just kick it out of recovery with iLiberty. That is what ZiPhone is doing automatically when you clicked on jailbreak.
     

Share This Page