Apple series 2 - Digital Crown

Discussion in 'Apple Watch' started by Covert_Op29, Jan 26, 2019.

  1. Covert_Op29 macrumors newbie

    Jan 26, 2019
    My Apple Watch out of no where started consistently talking to me as if I was non-stop holding the Digital Crown in. The actual crown is not stuck, so I can only assume its stuck inside somewhere. Has anyone had this issue? my watch continuously vibrates and annoyingly says "I didn't understand" every 5 seconds till it dies. At this point the watch is useless to me even when its off of my wrist. Any suggestions without telling me to toss it?
  2. Relentless Power macrumors Penryn

    Relentless Power

    Jul 12, 2016
    Not sure why anyone would tell you to ‘toss it’, but have you tried powering it off and then does it perform the same action when you power back on? Also, do you receive the same response if you press the digital crown in?
  3. Newtons Apple macrumors Core

    Newtons Apple

    Mar 12, 2014
    Jacksonville, Florida
    Have you had Apple take a look at it?

    It is sad but the Apple Watch is just barely serviceable and most the time replaced.
  4. waw74 macrumors 68040

    May 27, 2008
  5. Covert_Op29 thread starter macrumors newbie

    Jan 26, 2019
    I've done all the things I should "powered it down, powered down the phone, soft reset both, unpaired it and paired it again". cleaning it isn't the issue like others have issues as I said the crown moves correctly on the outside. I called apple and they walked me through making sure I did everything I should, which I did, and the only thing they told me to do is to have it sent in and looked at. That costs almost the price of the watch... ridiculous
  6. rgyiv macrumors regular


    Jan 30, 2018
    Did you even try cleaning it as referenced in the article @waw74 provided? Wouldn't hurt to try.....or are you sending it in?

Share This Page

5 January 26, 2019