Become a MacRumors Supporter for $50/year with no ads, ability to filter front page stories, and private forums.
Status
The first post of this thread is a WikiPost and can be edited by anyone with the appropiate permissions. Your edits will be public.
I have plenty of black cases, none of them do I need to clean on a regular basis.

Not sure why anyone, you or anyone else, would think that’s normal
I noticed this with my Sheaths over the past few years. My theory (it’s just a theory) is that the rough surface acts as a kind of sandpaper that lightly abrades the skin, which builds up over time causing the gray haze.
 
Open Paragon
 

Attachments

  • IMG_0048.jpeg
    IMG_0048.jpeg
    433.6 KB · Views: 4
  • IMG_0047.jpeg
    IMG_0047.jpeg
    439.3 KB · Views: 4
That's your answer lol I have 3 black cases here that don't need cleaning, I only buy black.
Well yea that’s what I’m saying. I’ve had a gray Sheath for over a month and never had to clean it once. Get a gray Sheath and the worry is over. I’m getting my black Sheath today and I will report if I have this issue ;)

#sheathgang
 
Last edited:
Got a chance to install the replacement batch that supposedly has better hole alignments, and it’s much better. The lens cutouts are still not 100% centered but much better than the old batch. The bottom speakers are perfectly aligned whereas previously, the speakers were a bit higher up.

1765068811249.jpeg

1765068834596.jpeg

1765068867903.jpeg



Lip of the case catches the skin and it just peels off.

You can apply skin to the bottom and two sides but not the top. Carefully pull the sides and insert iPhone. Then slide it down. Then snap the top corners.


Full back and Plateau should be ok.
I just said F it, might as well just try the full body skin since I paid for it, and if the top peels off, then I’ll just toss it. To my surprise, none of the sides peeled off.

@Sal09 Not sure if you waited a full 24 hrs for the adhesive to cure, but thats what I did. Also, what I did was put the top in first, then pulled the bottom of one of the corners, push the phone in, then pulled the opposite corner and side while simultaneously pushing the corner of the screen down. You can barely tell on the back.
1765069110849.jpeg

1765069128743.jpeg



Also, no exposed aluminum on the front. Looks exactly the same as before the skin was installed:
1765069158369.jpeg


Not sure if the cure time or technique worked, but I’m overall very happy with how it went. Definitely takes a LOT of patience to align the skin before squeegeeing out the water and carefully heating up the edges, while pushing down with your fingers, making sure not to stretch it. 🥵

Just a note for those interested in the full body skins, the sides are not 100% covered due to the curvature of the frame:
1765069181314.jpeg
 
Last edited:
Register on MacRumors! This sidebar will go away, and you'll see fewer ads.